- Vehicle and mobile computers
- Mass storage device interfacing
- Video camera interfacing
- USB data loggers
- High speed Flash SSD storage
The COM-1440 high speed USB 2.0 board is designed to
interface various standard USB devices.
Application coverage is increased with the introduction
of two high power USB ports
allowing direct powering of devices from the COM-1440
board. Two of the four downstream
ports support 500mA drive and two ports can supply up to
2A. These switches allow powering
of USB devices through the cable simplifying power
supply design of the system. Ideal
applications for the COM-1440 board include various
removable or fixed mass storage media,
USB memory keys, printers, cameras, CD drives etc.
Devices such as a high speed USB 2,5"
hard drive The USB header pin outs follow the general
standard scheme of USB ports.
The COM-1440 is designed to accept two M-Systems uDOC
secured and encrypted solid state
flash disk devices with capacities ranging from 64 to
2048MB each. These devices are
accessible as independent logical disks and are
available in extended temparature ranges
of -40 to +85°C. The two memory device sockets are
connected in paralell with two of the
external USB ports. High performance on-board rugged
extended temperature range solid
state storage with high throughput rates (20MB/sec read
and 10MB/sec write) using USB
2.0 is the modern design approach to advanced embedded
systems.
The Philips PCI-bus high performance USB controller
supports all Hi-Speed USB transfer
speed modes: high-speed (480 Mb/s), full-speed (12 Mb/s)
and low-speed (1.5 Mb/s). The
four downstream ports allow simultaneous connections of
USB devices all working at
different speeds. Compliance with USB 2.0 and 1.1
devices is guaranteed at all speeds.
- Dimensions: 90 X 96mm (3.6" X 3.8"), height 15mm (0.6")
- [COM-1440-A0] PC/104-Plus module with 4 USB 2.0 ports 2A
drive ETR -40 to +85°C
- Conformal coating
- uDOC devices mounted on board
